Where to buy Firmware updater USB WiFi config Log uploader Guides
Home My Devices Jupiter settings
DashboardTrackingLive Device InfoGeneral SettingsOutput ConfigArming & SafetyRules & AutomationsExpansion & AccessoriesCalibrationLoggingSIM & CellularAdvanced FeaturesCustom DatasetsBlack BoxSettings Queue & History
···
Checking arm state…
Jupiter3640···
connecting…
- -
—
CPU 20s— 3m—
View all device info →
Position
Sats-  -
hAcc-m
HDOP
-
AssistNow
-
GNSS alt
-
Pressure alt
-
Power
Batt-V
Cap-V
4V24.2V-V
CPU 20s100%-%
CPU 3m100%-%
Buck boost mode
-
Exp power
-
Signal
CSQ-/31
Net--
RSRP
-
RSRQ
-
Reconn
-
Expansion
EXP1Not connected
EXP2Not connected
EXP3Not connected
EXP4Not connected
Magnetic orientation
Heading
-
Declination
-
Field (µT)
-
Attitude
Roll
-
Pitch
-
Yaw
-
Tilt
-
Thermal
MBoard
-°
DBoard
-°
CPU
-°
Outputs
OUT1-
OUT2-
OUT3-
System
Disk-MB
RAM free
—
Uptime
—
Light (lux)
-
Device
Firmware
-
Boots
-
Last reset
-
Read-only view. This is a shared demo Jupiter, so you can look around every page but nothing can be changed or sent to the device.
Jupiter3640
Advanced Features
Air brake
Settings are saved to the device now, but the control loop is not running yet: nothing will move. The predictor uses the rocket mass, drag coefficient and reference area from General settings, so set those first or the target is meaningless.
No expansion port is set up as a servo output yet, so there is nothing to drive.
m1 to 10000
%0 to 50
°-1 = retract
°-1 = minimum
API key
A key for reading this device's data from our API, so you can build your own tracking or settings apps. Nothing uses it yet. It is not sent to the device and it grants no control over it.
<hidden>
Jupiter settings
Settings sync

We’ll check the device’s settings hash against the website’s copy. These should always be in sync, and this confirms they absolutely are.

Type the code above to confirm.