- Featured
Firmware updatev1.2
Flight log uploadv1.1
Online USB Portalv1.0
Online USB WiFi configuratorv1.1- All tools
3D parts toolv1.0
Air hole calculatorv1.0
Altimeter Cloud APIv1.0
Altitude Predictorv1.0
Body Tube Strength Calculatorv1.0
Descent calculatorv1.0
Ejection Charge Calculatorv1.0
ESP web programmerv1.0
Fin Flutter Speed Calculatorv1.0- Firmware updatev1.2
- Flight log uploadv1.1
Flight log verificationv1.1
GNSS seed datav1.0
Inland Water Mapv1.0
Laser Cut Parts Designerv1.0- Launch Site Survey, Weather & Predicted Landingv1.0
Line of Sight & Radio Pathv1.0
Main Roads Mapv1.0
Nano USB Settingsv1.0- Online USB Portalv1.0
- Online USB WiFi configuratorv1.1
Power Lines Mapv1.0
Rail Exit Velocity Calculatorv1.0
Recovery Drift Calculatorv1.0
Tree Canopy Height Mapv1.0
Visibility & Tracking Calculatorv1.0
Wind Turbine Mapv1.0
How to prepare your Snapshot Screen V1 for updating
Connect and enable update mode
Connect your Snapshot Screen to your PC or laptop with a USB data cable (not a power-only charging cable).
Hold the BOOT button and briefly press the RESET button.
The screen will go dark and stay dark — there's no on-screen indicator for boot mode, but your Snapshot Screen is now ready to receive firmware.
Use a supported browser
Web-based firmware updates require Web Serial, which is supported only in desktop Chrome, Edge, Opera, and other Chromium-based browsers. Firefox and Safari will not work.
Mobile browsers probably are not supported either. You must use a PC or laptop.
Use a data USB cable, not a charge-only one
Many USB-C cables, especially short ones bundled with phone chargers, are wired for power only and have no data lines. These will charge your device but cannot communicate with it, so the updater will not be able to detect your device.
If you have problems connecting to your device this is probably why.